SunEarth Inc - Quality Solar Water Heating Products

SunEarth Inc - Quality Solar Water Heating Products
 

Sizing Heat Exchangers

Proper sizing of heat exchangers is critical to realizing the full performance of any closed-loop solar system. There exists some sentiment in the field that closed-loop designs are much less efficient than their open-loop counterparts, but this is to a large degree caused by improper sizing of the heat exchanger. Many of these problems were likely caused by sizing heat exchangers for typical boiler applications instead of solar.

In traditional boiler systems, 180 F water is used to heat up water at 100 F from storage. The difference between the hot and cold fluid is called the ‘approach’, and in the case of boiler systems is on the order of 80 F (180-100). In solar applications we want the collectors to be running as close to the storage temperature as possible so that they operate at maximum efficiency. Achieving this requires that the approach be brought down to the range of 10-20 F, which requires a significant de-rating of the output numbers of most heat exchangers that are rated for boiler applications. The guidelines provided below are based on low approach solar temperatures where the maximum heat load is determined from typical operating temperatures under full sun conditions. When sized to these principals, the closed loop system will operate within 5% of open loop efficiency for brazed plate units and on the order of 10% for tube bundle applications.

Sizing External Brazed Plate Heat Exchangers

Sizing External Brazed Plate Heat Exchangers

Because of their high efficiency and compact size, brazed plate heat exchangers can be economically sized for very low approaches on the order of 10 F. This low approach results in system efficiencies that parallel open-loop designs. SunEarth carries two brazed plate units under the SunPlate tradename. The smaller SPL31 series can handle 9 ft2 with each plate while the larger SPL110 has a capacity of 50 ft2 per plate. For more information on sizing SunPlate units visit the SunPlate page on our website by clicking here. Pressure drops across the SunPlate units at design flow rates are typically 1.5 psi.

Sizing Immersed Tube Bundles

Sizing Immersed Tube Bundles

Immersed tube bundles typically operate at much lower efficiencies than brazed plate heat exchangers. This happens because they rely on natural convection to transfer heat away from the bundle. Due to lower operating efficiencies, it is only economical to size tube bundles for a 20 F approach. Although actual heat transfer depends on bundle configuration, a good sizing guide is to use a square foot of tube bundle for every 14 ft2 of collector array. This sizing should result in an approach on the order of 20 F. Pressure drops across tube bundles at design flow rates are typically on the order of 1 psi.

SunEarth News

SunEarth Supports 2017 Solar + Storage Worker Day

  SunEarth, along with solar companies from across California, will gather to support the future development…

Read More

A BRIEF NOTE ABOUT SUNEARTH “CERTIFIED” and “LISTED” SYSTEMS

SunEarth provides its customers with several engineered residential, commercial, and industrial solar hot water heating products…

Read More

SunEarth, your Solar Energy Specialists, announces the latest in Solar Hot Water Stations.

SunEarth, your Solar Energy Specialists, announces the latest in Solar Hot Water Stations. Introducing the DRAINPACK…

Read More

Thank you for visiting SunEarth at Intersolar

SunEarth, along with Steca Elektronik, would like to thank you again for taking the time to…

Read More

SunEarth News
Case Studies
Customer Corner